Working as a plumber can be very rewarding. It will require installing, maintaining and repairing piping and water systems all over your location, in either commercial or residential buildings. The pay for this kind of work is usually quite good in a highly developed area.

It takes time to become a good plumber, i.e., he has to spend more time for his career to be successful. There are many areas where a trustworthy plumber like "wet only plumber" & in "Gas Industries". In the first type work is done in homes such as fitting bathroom, sprinkler system. Second type is very sensitive. To work in a gas industry one has to first achieve Council of Registered Gas Installer Certificate. Some plumbers normally work in domestic areas such as leaky taps & blocked sinks etc. Normally whatever field a plumber chooses the basic thing he must know is Water Regulations & Building Regulation.

There are two, one on each side of the toilet, closet bolts which hold the toilet to the floor. If there are caps over the bolts, remove or pop them open. Using a small crescent wrench unscrew the nuts from the bolts. Alternate side to side when unscrewing this will be much more important when reinstalling the water line repair bolts but alternate anyhow.



A c clamp or hose clamp is use full for securing or holding the rubber used to seal leaks on piping. However, a clamp should be used carefully considering the type of pipe being repaired, clamping too tight will fracture the pie leaving you with a bigger problem than you started off with.

The location of a plumbing contractor is a key factor. This is because he or she will not only charge you an hourly rate, but travel costs will also be charged. This can add a significant amount to the final bill if the contractor has to travel from the other side of town.

A broken water supply line can cause water to spurt from the line connecting the toilet to the main water valve. The first step to repair this leak is to shut off the water line repair supply valve. This will stop the flow of water to the toilet. Next, flush the toilet to remove the water from the bowl and hold down the handle until it is completely empty.

The way a toilet plunger works is by filling up with water and then pushing that water through the stopped up drain. When unclogging a clogged toilet, the idea is to plunge up and down a couple of times so the plunger fills with water and then jam the open end, sometimes called a force cone, into the waste outlet in the plugged toilet and start plunging. You may have to pump the plunger up and down several times to clear the blockage.

After completion of Plumber Training Course one can get job in a company or some may start their own firm. If a person is settled in this field there is a lot of scope to earn. There are some plumbers in UK with an annual income of more than a million.